E-cowlboy MG21103 Dana 30/44 Front Axle Tube Seal Pair For Jeep Wrangler JK JKU 2007-2018, YJ 1987-1995, TJ 1997-2006, LJ 2004-2006, Cherokee (XJ) 1984-2001, Grand Cherokee (ZJ) 1993-2001 (2PCS Black)

I have the disconnect axle in my '90 MJ and ordered this, aware of the claim that it would not fit because the disconnect shaft is so much larger on the inboard end. But it can be made to work on the right side. I removed the grease zerk, the clip holding in the seal, and the seal. Then I 1) cut the seal so it could be installed after the shaft was in and 2) opened up the inside of the housing on the lathe sufficiently to fit over the larger shaft. I then installed the seal in the axle housing and reinstalled the axle through it now widened enough for the large inner end of the axle to pass through. Since the axle is the same small size on the outboard end, I now put the seal over the top of the axle and pressed it in carefully so the zerk hole lined up. I then installed the zerk fitting and the spring clip which holds the seal in place. I made it a point to have the slice I made in the seal upward. It might leak a little water if fully submerged briefly, but heavily greased, as it should be, I believe it is a nice solution. The only thing to remember is if the shaft needs to be pulled, you need to remove the zerk and the spring clip. first. The seal will pull out as you pull the axle! Cool!!

They only fit on the driver's side . Did not fit on the passengers side to small .

Fit jeep jk spot 2011 axle.

Put them in my dana 30 on a 04 tj no worries really happy with them thanks

When you compare the price line of these to others that in fact are the exact same thing, this made these a true value. If you are a fan of mud then these are a must. the plastic factory ones do not keep mud out of the axle sleeve and this leads to rusting of the axle shafts. These seal up the axle tube and are a must for those mud bugs. These were installed in a 2009 Jeep JKU