Magic Home Gym Multigrip Wall Mounted Chin up Bar

Very good design, its very strong and stable while using, no jerks or any other unnecessary movements.Use M8 or M10 anchor bolts as shown in image for fixing, 14 mm drill hole for M8 and 16 mm drill bit for M10 bolts.

So i finally installed it . The equipmentis amazing especially when used with gymnastic wrings.Few things are important for installationNeeds M10 bolts the ones given are M8 and arnt suitable . You need to find it at some hardware shop.You need 16mm drill bit with a powerful wired drill.Be sure of the measurements and dont tamper with the M10 bolts or hammer them in .And you will be fine

1. Buy the fastener which I used[Photo attached] available and a pack of Araldite for firm placement2.first drill the marked holes with 8mm bit of appropriate length and then the same hole with 10mm bit with same length. The reason for doing this is to prevent the opening of hole becoming too wide. Minor Misalignment can frustrate your installation. Use Hammer drill for installation, normal drill wont work.3. Check the proper alignment of holes by just placing the fastener with bar on wall.4.Now prepare the araldite concoction. Use a Cardboard and a toothpick5.now apply the concoction on the fastener. Apply it properly don't skimp.6.Thrust the fastener and now the nail with a heavy hammer. Normal hammer won't work [depends on your strength]7.now same procedure for second bar. Make sure it is on same level with the already fixed bar and align it using horizontal bar provided.P.S: Buy 2 extra fasteners and don't' worry if while striking the hammer, fastener goes too much deep fill the hole with some white cement and remove the extra cement[If any] with drill.

It is a good product. But you need to have really good carpenter to fix it. Your wall should be strong enough to hold it. You need M10 bolt to fix it better. It may cost to Rs. 150/- are so.

I find it extremely reliable, tough and sturdy ... easy to do chin ups and pull ups since there is good grip and no loose or shaking parts. Difficult to install but if done properly then excellent product.I had to weld back side of horizontal rod to right & left vertical rods since no hole is provided for screws on back rod of horizontal rod.

The build quality is good but apparently the equipment is heavy and despite buying 6 inch long fixing bits instead of the 4inch ones provided with the product it does not stay stable in the wall and comes out.Impractical for domestic usage

The product is too good and sturdy with at most reliable experience while working out,but the installation process was quite difficult as the size of drill to be used and the lengthof drilling is not mentioned in the manual. Additional 2 fasteners are required to be providedin the kit for safety, if damaged. I faced this problem of damaging 2 fasteners because the drillbit size 10mm was not sufficient to install. To find the quality of fasteners like the one providedis not possible.

The quality of product is top notch. Very strong and easily you can rely on this for pull ups and chin ups this can easily handle upto a person of 80-90 kgs. The fasners provided with package doesn’t seem to be good. I’ll recommend you to use your own 18mm fasners for strong installation. BTW installation process is bit tricky and time consuming.