DLLT Industrial Directional Track Light Led, Indoor Round Ceiling Spot Lighting 3-Light for Living Room, Dining Room, Offices, Bedroom, Picture Wall, Kitchen, Warm Light, Gu10 Bulbs Included

nice product recommended

Overall very happy. Started with one, ended up installing 3, wife liked them so much!For manufacturer: Please consider a stiffer mounting bar or including spacers between bar and electrical box to make mounting bar perfectly parallel and flush with roof. As it is, the mounting bar ends up bending in a very slight U pointing down to the floor on both end by a few mm's and this makes it impossible to have the light totally flush with the ceiling.For Buyers: This light is bright! Dimmer is strongly recommended.I will come back in a few months to comment on longevity of the included bulbs.

This came with a burned out bulb. I installed it before I knew that. The next one came with three good bulbs. I took out a good bulb, stuck it in the installed lamp and put the bad bulb in the new lamp. I brought the box with the new lamp to UPS. They scanned my llilill thing on my phone and took the box. All done.The connection to the ceiling is okay. It’s not Yugo quality, but it isn’t even Plymouth PT Cruiser quality. Since nothing touches in, and it isn’t being jostled, it works fine.

I like that the lights can be pointed in different directions. Its cool looking and looks great in my tiny kitchen inside my tiny lake house.

We bought two of these for a huge, L-shaped linen/storage closet in our master bath. It's worked so well getting light to all areas in the space, we're ordering the two-light version for our two reach-in closets. (At this point in our lives – our country – it's absolutely wonderful when things just work as you thought they might!) <3

The fixture looks nice but is extremely difficult to change the bulbs. I read the reviews about the cheap bulbs that are included so I bought better bulbs to replace them before installation. It was almost impossible to unscrew the ring that holds the bulbs in place. There is no way the bulbs could have been removed if the fixture was installed on the ceiling. Also, the ring that holds the bulb in place is chrome, a different finish than the rest of the fixture’s satin nickel body. The fixture is made for cheaper low profile bulbs. Better quality bulbs are slightly taller so it is a challenge to push the ring down and tighten it into place. My photos show the fixture with an expensive GU10 bulb and how the ring sits with the new bulb. ADDITIONAL COMMENTS AFTER INSTALLATION: The seller has great customer support and sent a replacement. Both light fixtures had the same problem but I was able to better analyze it. Some of the chrome rings that hold the bulbs in place were extremely tight. Not all of the rings were tight. Also, one of the rings had a tiny bit of rust inside which over time in a moist environment could cause a problem. I chose 3 rings that worked the best but still had to struggle to squeeze down the expensive full-spectrum bulbs that I purchased. It was a struggle. I ultimately used a silicon sticky mat to unscrew the ring which really helped. The fixture was a breeze to install to the ceiling and looks great. It compliments my kitchen and it's stainless steel appliances. All in all, the struggle was worth it. The fixture looks great.

Was looking for a bright but possibly dimmable ceiling fixture for my office. This fixture looks great and with a dimming switch works great.Product was as described and came on time. Great value as well.

I love it. I was updating a small half bath. It was a great addition.