20 Sets Mini Micro Sh 1.0 Jst 4-Pin Connector Plug Male with 150mm Cable & Female

Good connectors and pig tails. Couldn’t use them as they were to small.

I mistook the connector that I needed for the one here so I haven't gotten to use these, but they are as pictured and seem sufficiently well made. I will keep these for any future projects that I may require such a connection for.

Good product but too small for what I needed. Pay attention to the ga. wire.

I accidentally ripped the jst connector on my keyboards daughterboard and this was an easy to replace connector. Note that these would be perpendicular to the pcb.

I had to go through every one I got and snip and splice the correct color (based on black = ground, red = vcc, blue = SCL, and yellow = SDA) wires on. I use the Adafruit and Sparkfun standards. But even without those the black and red were reversed so make sure to test that the wires are what you think they are if you decide to get these. AFAIC I will not be buying these again and looking for ones that can at the very least get positive and negative correct

Not what i was expecting. Much smaller than i realized. Not sellers fault, only my own.

Ok

I had to search a bit for these, they fit my Treedix 2pcs 2x20 GPIO Header Connection Ports PI Hat GPIO Breakout Board GPIO Connector boards just fine!