6Y2-24306-55-00 6Y2-24306-56-00 Boat Fuel Line Assembly Kit 1/4 Inch Pipe 10 Feet Marine Outboard Fuel Hose with Connector and Primer Bulb Compatible with Yamaha Outboard Motors

Smaller 1/4” line is just what I needed to run my log splitter from a remote tank. Fitting works perfectly with my Yamaha adapter on a portable 6 gallon tank.

Boat

Used with a 6 gallon tank and 90 hp Yamamha Outboard. The connectors have spread/softened (maybe heat) at each end so each connector will back off enough to release the spring pin on the mating connector, thus cutting off fuel supply. Purchased May 2024 and now it's Sept 2024. Pretty much useless.

When weather takes it toil, this was so easy to change into a new line.

At some point this summer, I will be restoring my old 16ft skiff to good working order, and this will inevitably involve replacing the fuel cable, bulb, and fuel tank.I ordered this fuel line, but haven't yet got around to installing it. What I can say about it from first impressions are positive.The crimps used appear to be stainless steel (will hold up in saltwater). The fuel line ends are well constructed, just need to make sure you have the proper male ends to pair. In all likelihood, I will probably cut the ends off and connect the fuel line at tank/motor using a barb connection and hose-clamp. Over the years I've found that this is the most reliable connection, as after a few years these quick-disconnect ends will end up letting air into the fuel line.The hose material is not reinforced with any braid, so it does kink easier than a reinforced fuel line, but the hose doesn't feel cheap either (similar to what yamaha/honda supplied with their outboards).So far no complaints, If I encounter any during installation later this summer, I'll revise my review, but otherwise it looks like smooth (rather gas-powered) sailing from here.

Easy hook up. great quality. Kept this line as primary and used the line from West Marine as a spare.10 of 10 would by again.

The hose and bulb are ok,but the fittings that are supposed to fit the motor and gas tank do not seat fully. I cut the fittings off my old hose and put them on the new one and it works fine. If you need new fittings look elsewhere. Yamaha 15 HP 4 stroke.

The fuel tank seem well made , but the filler cap doesn't vent off pressure .The fuel tank gets bloated when it warms up .I open the filler cap to release built up pressure .And after a year the fuel line & bulb are getting hard .Will have to buy a replacement fuel line in a year .