Flexible Jerry Can Spout/Nozzle Gas Canister Rubber Nozzle Fits for 5litre, 10litre and 20litre Military Spec cans

These fit my authentic SMALL MOUTH NATO cans I purchased from Coleman's surplus.They come with a gasket already, which I permanately affixed with some 2-sided foam tape.

This spout works BUT would be nice if it had a cap to close it between uses.changing this to the cap that came with the can each time you use it is fine ifyou are moving it in a truck ... but storing it in the shed and filling a mower every few hours,can be a pain closing it each time.

Gasket doesn't stay in place. Doesn't form a tight seal to the can and leaks a lot.I'm using Wavian NATO cans.

fast shipping

Wish it would have a cap to prevent evaporation when storing in my garage.

Need one for my Ural factory can fits tight like it should

I had purchased these for my well built red and yellow fuel cans. The effort put into manufacturing these fell far short of the quality of the cans. I had expected a suction vent to aid in the ease of pouring, but I had not expected them to have a hole through which to leak right from the spout all over the place.The rubber seal fell out almost as fast as I was able to remove it from the packaging. The surface where a seal was supposed to be achieved had multiple bumps in it which would have made achieving said seal a challenge. They are too much of a hazard to try to use.

I have a wavian Jerry can. This does not fit.