🚀 Elevate Your HVAC Game with Mega Flow Power!
The Appion MGAVCR Mega Flow Vacuum Rated Valve Core Removal Tool is a high-performance tool designed for HVAC professionals. With a 5/16" system connection and weighing just 2.0 lbs, this tool combines precision engineering with user-friendly design, making refrigerant recovery faster and more efficient. Proudly made in the USA, it's built to last and perfect for any job.
M**S
Quality tool
Works great. Replaced the leaky valve core easily.
L**U
Works As Intended
Did the job during my mini-split install.
R**T
Remove that valve core!
Very good quality tool, a must have for a mini split install or repair. You must remove that valve core to get a good deep vacuum. And in my case, I also had a leaky valve core, I had to replace that valve core. This tool made the job easy.
M**B
Excellent Quality
Needed new core removers for a new 410A system at my house. These sealed the system perfectly for my pressure and vacuum testing. I'd highly recommend paying a little more for these so you are not chasing ghost leaks like I was while using adapters on other valves.
J**G
This is the valve core removal tool to get
As a consequence of installing a pre charged condenser heat pump system, a valve core removal tool is a key element needed for the setup of the system. It is used with a pressurized nitrogen source to test the line set installation for leaks, and also with a vacuum pump to evacuate the line set prior to adding refrigerant.I initially attempted to perform the tests with similar cheaper devices, but I discovered that there were vacuum leaks with one, and un-reliable shrader valve capture with another. Save your time and get the Appion one, which is also the choice of many pros.
M**R
Works well, but I suggest buying a few more parts to use for mini split vacuum.
Used to install a mini split. Fit perfectly and the schrader removal tip fit nice and tight onto the schrader valve. Appion then expects you to retract the schrader and close the valve and remove the back part of the tool to connect a vacuum line. The issue with that is that once it is pumped down, and the vacuum line is removed, a small amount of air will be introduced into the system when the schrader valve is re-installed. I suggest adding a tee and a valve to the gauge port so that the schrader stays inside the tool and under vacuum the whole time. Never close the valve on the Appion tool.I am happy that the seal on the back of the appion tool was able to hold great vacuum during the evacuation and I was able to then re-insert the schrader maintaining good vacuum the whole time. Nice product, though I think they should redesign with a second port and valve near the gauge port to use it as I did.
E**Y
Great valve
Made in USA. Excellent build quality. Why trust anything else when you can be sure these will work?
O**.
Schrader puller vacuum port
Works great, I have used them for over a month now and have had zero issues. Highly recommend.
Trustpilot
2 weeks ago
2 months ago
