Blower Rack Compatible with Stihl BG-50, BG-56, BG-66, BG-86, Handheld Blower Holder Mount Rack, Lawn Care Accessories, Garage Storage, Weed Eater Hanger

This is a good product, holds my BG-86 blower with no problems. One thing to note is that I thought this might hold the blower without the bar going through the top slots (which is used to lock it in the holder) and it does, but only sort of. The nozzle will hold it in there, but if you bump the blower it could come off. So, it is best to not leave it to chance and put the bar in to keep it in place. To be clear, I didn't read anywhere that I thought it would, but just so you, the potential buyer, know!

A little pricey, but well made bracket. The only negative thing I can say is the padlock that comes with it is a joke. You could break it with your bare hand. Think an oversized version of those cheapy suitcase locks. They could have left that out and charged less. The other thing is that there are 4 slots on each side of the bracket. You put your blower in the bracket, and then slide a bar from side to side through the slots. I have 2 Stihl blowers (different models) and neither uses the same slot position on both sides. This results in primary contact against one side of the blower, and almost nothing on the other. It still holds well, and I'd buy another if I needed one, but that part of the design could use some refinement. In short: Yes, I would recommend this to a friend.

The media could not be loaded. Well, worth your money to keep your tools locked up.

I feel like the little piece of steal in back (slides in to hold the blower )is kind of Chauncie. I plan on putting this on a vehicle inside of a trailer so it may not be best for that moving down the road so far so good.

For anybody that has been moving their Stihl leaf blower all around their garage or shed, this is the bomb! Ten minute install and your problem is solved! Wish I would have found it sooner because, while I love the leaf blower, I didn't love walking around it, or putting it on something I would eventually have to move it from .Worth twice the price!

I attached this thing to my shop wall (not a landscaper trailer). Its screw pattern is not designed for a wall, i.e., the three screw holes in a downward pointing triangular pattern place the lower hole as the stud hole and the upper two holes in the sheet rock. This is backwards - the holes pattern should point up so the center stud hole is on top.The plate is painted nicely but still smells really metallic.The plate holds my Stihl BG85 well. This is my first time hanging my BG85. Normally it is easy to start, but after hanging vertical for several days, it was very difficult to start. Leaving it horizontal for several days, it was easy to start again. I did not dump the gasoline. Next, I'll try dumping the gas before hanging.

Perfect fit! Cleaned up the old way of storage.

Perfect fit for my leaf blower. Don’t use the locking capability but its a great extra feature